Download the latest version of Haldex Diagnostic Software, also Firmware for ECU and Diagnostic Interfaces.
Please handle any software update with care! If you are in doubt about the procedure please contact your local Haldex contact.

⇓ Diag+ v6.19

Universal software tool für EB+ and U-ABS diagnostic. Supports multiple languages.
ECU programming requires USB Dongle (Serial Dongle not longer supported)
PC operating system: Windows XP - Vista - 7 - 8 - 10

⇓ Flash update for EB+ GEN 1 / 2 / 3

This updater can be used with all EB+ generations. It will detect the connected EB+ Hardware and continue with the required software.
Updater v1.0

  • C616 – GEN1 1M/2M
  • C617 – GEN1 3M
  • C618 – GEN2 2M/3M with MC (Atomic)
  • D720 – GEN2 2M/3M with MC (FJ3)
  • E732 – GEN3

Note: We have been notified of a number of GEN3 ECU’s that cannot be re-flashed, which could affect units with software earlier than E707. The units operate correctly but will not allow the units to be re-flashed. After a failed re-flash attempt the parts continue to operate correctly with the original software.

Attention:

Haldex recommend not to flash update any of our EB+ products, until advised to by Haldex.

⇓ Fleet+ v3.31

Analysis tool for EB+ data logs.
For EB+ GEN2 manufactured from Q4 2009 with ECU software C499 or later. Requires PC interface dongle part number 815 023 011. Supports multiple languages.

⇓ Fleet+ v2.9

Analysis tool for EB+ data logs.
For all EB+ variants. Does not require a special dongle, but has limited function compared to v3.x. Note that this program is an English language version.

⇓ USB Dongle Driver

CDM v2.12.26 WHQL Certified
Use this driver installer in case of problems with your Haldex USB Interface or if the driver installation needs to be fixed.